2820Re: Software setup
- May 7, 2013The X-Fi is not supported but is a good card for RX only
bearing in mind that it will only be effective for 48KHz
because of an inbuilt LPFilter. Also there will be high latency.
In order to have Cat control you will need to set up virtual com
ports on the PC that PSDR runs on. However PSDR-IQ will not
take control of an FT990. It will only control the flex Radio
systems and a Sis570 in a softrock through a USB port using the
correct driver. The Softrock lite does not have a Sis570 VFO
or a USB control as it is crystal locked.
One sets up the PSDR_IQ in IF mode for the purpose of using the
panoramic display etc. Rig control will need to be with another
program via your existing com port.
Regards 73 Eric VK5ZAG
--- In firstname.lastname@example.org, "ve3tmt" <ve3tmt@...> wrote:
> Hi group,
> Just dabbling with the software and have a few observations/questions. Setup is a Softrock Lite II tapped on the 455 KHz IF of my Yaesu FT990. Sound card is a Creative Labs X-FI PCI card.
> I do not see this sound card listed in the setup. Is it not supported?
> I tried to set up CAT control of the 990, COM3 4800 N 2 but it will not recognize the radio.
> Any suggestions?
- << Previous post in topic Next post in topic >>