Loading ...
Sorry, an error occurred while loading the content.
 

Re: Enhancement idea: Spell checking and OnDocumentClose event

Expand Messages
  • jdfmike
    Larry: Doesn t the existing onClose event refer to the clip library rather than the active document? I was wanting to run the clip whenever the active
    Message 1 of 5 , Mar 1, 2004
      Larry:

      Doesn't the existing "onClose" event refer to the clip library rather
      than the active document? I was wanting to run the clip whenever the
      active document is closed.

      PS: Thank you for the tips on how to run the spell checker via a clip.

      --- In ntb-clips@yahoogroups.com, Larry Thomas <larryt@c...> wrote:
      > At 04:58 PM 2/29/04 -0000, you wrote:
      > >I may be wrong but I don't believe there are any clip commands to run
      > >the spell checker against a document. If there aren't then would there
      > >be any interest in the following:
      > >
      > >- New event: OnDocumentClose
      > >- New clip command: ^!CheckSpelling
      >
      > Sorry, I did not see your request for a New event. That already
      exists in
      > NoteTab as well.
      >
      > Change:
      >
      > H="Spellcheck and Save File"
      > ^!Toolbar Spell Check
      > ^!Save
      >
      > To:
      >
      > H="OnClose"
      > ^!Toolbar Spell Check
      > ^!Save
      >
      > You need to know that this will only spell check the currently focused
      > file. If you are working on several files and want to spell check
      and save
      > them all, you will have to run the first clip on all but the last
      one and
      > if your file is not in focus it will not be checked. Only the
      focused one
      > will be checked.
      >
      > You should also know that only one clip can have this name in the
      clipbook
      > library and that library must be currently open and active when you
      close
      > NoteTab or it will not run. It does not have to be displayed
      however, you
      > can hide the clipbook panel by pressing Ctrl+F12.
      >
      >
      >
      > Regards,
      >
      > Larry
      > lrt@n... e¿ê
    Your message has been successfully submitted and would be delivered to recipients shortly.