Loading ...
Sorry, an error occurred while loading the content.
 

RE: [nslu2-linux] Re: Got Serial, Got root Now the firmware

Expand Messages
  • Sopher
    Can you elaborate on the exact steps to do this? I could try, but I m sure _I_ would brick it myself. Use as an example this firmware file:
    Message 1 of 3 , Sep 1, 2004

      Can you elaborate on the exact steps to do this?

      I could try, but I’m sure _I_ would brick it myself.

      Use as an example this firmware file:  nslu2-busybox-1.0-rc3-halt.tar.gz

       

       


      From: Paul Bartholomew [mailto:paulbart@...]
      Sent: Wednesday, September 01, 2004 4:42 PM
      To: nslu2-linux@yahoogroups.com
      Subject: [nslu2-linux] Re: Got Serial, Got root Now the firmware

       

      --- In nslu2-linux@yahoogroups.com , "Sopher" <Steve@w...> wrote:
      >> Is the firmware best uploaded via the Linksys web page upload?

      I definitely don't trust their web page upload - I 'bricked' an
      NSLU2 the first day I got it.

      Their update method appears to be flawed: they seem to be "OK" with
      re-writing the Redboot section of Flash.  If that fails, then you're
      screwed.  They should never re-write Redboot, IMO.

      Going in via telnet/serial port, and manually re-writing mtd2/mtd3
      seems safest to me - if it fails, you can always get control of
      Redboot, and try again.

      Also, Redboot has the "fis erase" and "fis write" commands.  I
      haven't tried them, but I think they'd be as good/safe as
      the "mtd2/mtd3" re-writes from Linux (except you need to be careful
      with the "fis" commands, since you're specifying addresses in the
      Flash chip (a missing digit in an address could potentially screw up
      Redboot, for example)).

      - Paulb





    Your message has been successfully submitted and would be delivered to recipients shortly.