Re: Really slow writing files over network via samba and scp?
- --- In firstname.lastname@example.org, George Styles <yahoo2@r...> wrote:
> One more clue - in dmesg i seeThe dmesg output of my working slug (unslung5) is not identical to
> Initializing IXP425 NPE Ethernet driver software v. 1.1A
> ixp425_eth: CPU clock speed (approx) = 0 MHz
> [error] ixEthMiiPhyScan : unexpected Mii PHY ID 00008201
> ixp425_eth: npe0 is using the PHY at address 0
> ixp425_eth: npe1 is using the PHY at address 1
> ixp425_eth: ixEthMiiLinkStatus failed on PHY0.
> Can't determine
> the auto negotiated parameters. Using default values.
> Should I worry about the 0HMz bit?
the openslug output above:
Initializing IXP425 NPE Ethernet driver software v. 1.1
ixp425_eth: CPU clock speed (approx) = 0 MHz
[error] ixEthMiiPhyScan : unexpected Mii PHY ID 00008201
ixp425_eth: ixp0 is using the PHY at address 1
ixp425_eth: ixp1 is using the PHY at address 0
ixp425_eth: ixEthMiiLinkStatus failed on PHY0.
the auto negotiated parameters. Using default values.
Look at the 1.1 vs 1.1a. ixp0 and ixp1 is reversed.
Don't know if this matters.
- On Tuesday 04 October 2005 15:02, George Styles wrote:
> eth0: negotiated 100baseT4 flow-control, link oktry miitool -v for verbose output. I'm under the impression that there is a
> eth1: negotiated 100baseTx-HD, link ok
confusion somewhere in the driver-kernel-miitool chain so the status of eth1
is the status our eth0, the autonegotiating, the Tx, all say that those are
the actual parameters of the 'real' eth0. One note, IIRC the HD means
HALF-duplex operation ? That's most certainly not fun on network intensive
> interface, the LED indicates that it has switched to 10... Doing itIf you are doing this sort of thing try disconnecting/reconnecting the cable
> on eth1 makes the slug hang (or at least fall off the network).
after the command (and wait a few seconds), especially if you are going
through a switch/router, I've seen too much broken autosensing equipment to
trust it will work just right...
> Should it see 2 ethernet devices? maybe thats what my problem is?The Intel chip in the slug has two ethernet ports, it's just that only one is
implemented on the NSLU2 board, so that should be okay.