Loading ...
Sorry, an error occurred while loading the content.

Re: [nslu2-linux] NSLU2 Help - no IP address

Expand Messages
  • Mike (mwester)
    ... Follow the instructions on the wiki to enter upgrade mode using the reset-button method. No firmware other than the original Linksys firmware has a
    Message 1 of 6 , Jun 25, 2008
    • 0 Attachment
      Joel Scaria wrote:
      > How would I go about reflashing the original firmware? The Linksys web
      > interface is unavailable because well...I can't access it via my network
      > since it's not getting an IP address.

      Follow the instructions on the wiki to enter upgrade mode using the
      reset-button method.

      No firmware other than the original Linksys firmware has a web-based
      upgrade mechanism, so you need to use the reset-button technique in all
      standard cases anyway.

      >
      > On Sun, Jun 15, 2008 at 12:52 PM, Klaus Ruebsam <k.ruebsam@...
      > <mailto:k.ruebsam@...>> wrote:
      >
      > Try reflashing the original firmware as of Linksys. Then restore the
      > slug to
      > it´s factory default network!!! settings (using the LinkSys
      > firmware). Now
      > get the slug again into update-mode and then try again flashing the
      > debian-installer image.
      >
      > That did the job already twice for me (as I normally do not use the
      > default
      > IP-addresses).
      >
      > Bare in mind to NEVER EVER use the EraseAll tool as it will permanently
      > break the slug!!!
      >
      > Good luck!


      Mike (mwester)
    Your message has been successfully submitted and would be delivered to recipients shortly.