Can't boot from disk1 after plugging in disk2
Yesterday I successfully unslung my NSLU with Unslung 5.5 after
following the instructions on the Wiki. The rootfs was mounted
off of disk1 and everything was working perfectly well. Today,
I wanted to add a non-NSLU formatted disk on disk2. It is an
ext3fs file system but it wasn't formatted using the Slug.
The disk was recognized (I checked when telnetted in; it wasn't
recognized in the Web interface) and I mounted it by hand.
I then rebooted with both disks plugged in. The Slug stopped
booting from this point onwards, as long as the unslung disk
(disk1) is plugged in. If I unplug the disk and boot with
no disks attached, everything is fine, disk1 is recognized post-
bootup. I've tried unslinging disk1 again but it makes no
difference. I can still only boot off the flash rootfs and not
disk1. In this situation, the Slug doesn't ping, etc.
Can anyone help me here? I've gone through the Wiki again and
again but haven't seen anything which describes a solution to