Re: Help with SerComm Upgrade
- I recently upgraded a NSLU2-clone to 6.8 using upslug2. I understand
that upslug2 works basically the same way as the sercomm tool.
When you hold in the reset switch and get the unit into upgrade mode
(I assume that's what you meant) it moves it's IP to 192.168.0.1.
I had a second network adapter fitted so I configured that to the
192.168.0.*** subnet and used a crossover cable.
I'm not certain but I got the impression from the wiki that the
upgrade tools (sercomm/upslug/upslug2) ignore IP altogether and just
go by MAC address.
The switch built into a typical router should work OK. What you
can't do is cross the router Eg PC on LAN port, slug on WAN port
--- In email@example.com, "h8dc" <h8dc@...> wrote:
> --- In firstname.lastname@example.org, Airw0lf <aerwulfe@> wrote:
> > Hi,
> > I want to upgrade to Unslung 6.8 using the Sercomm utility. I
> > installed the utility but it cannot seem to find the SLUG (I
> > browse targets, but the device list comes up empty.) Is this
> because I have
> > not put it into upgrade mode as per:
> > Is it also necessary to have a direct connection to the slug, or
> does it
> > matter if I am connected to a router?
> It works connected to a router.
> > Does the slug's IP address matter? It
> > currently lives in the 10.1.1.x range...
> Must be in same subnet as the rest of your network, I believe.