Loading ...
Sorry, an error occurred while loading the content.

309Re: Compatibility with USB card readers ?

Expand Messages
  • pdsavio
    Oct 15, 2004
    • 0 Attachment
      Thanks for the tip, I was using a multi-card reader. I should probably
      just get a simple CF only reader.

      --- In nslu2-general@yahoogroups.com, "peecock41" <peecock41@y...> wrote:
      >
      > --- In nslu2-general@yahoogroups.com, "pdsavio" <pdsavio@y...> wrote:
      > >
      > > I'm trying to use a compact flash card with a USB card reader attached
      > > to drive 2 port of the nslu2. This does not work. How is this
      > > different from using a USB flash stick (which happens to work fine)?
      > >
      > > I tried searching earlier posts for an answer but did not find
      > > anything.
      >
      > I've got an el-cheapo compact flash card reader which works fine, as
      > it is seen as a flash stick.
      >
      > Mind you, I've tried a multicard reader (i.e. CF, SD, etc) and it
      choked.
      >
      > Here's the output of /var/log/messages when I (hot)plugged it in:
      >
      > <46>Oct 15 19:16:41 klogd: hub.c: new USB device 00:01.1-2, assigned
      > address 2
      > <44>Oct 15 19:16:42 klogd: Protocol: Transparent SCSI
      > <44>Oct 15 19:16:42 klogd: before kernel thread
      > <44>Oct 15 19:16:42 klogd: *** detect:usb-storage
      > <44>Oct 15 19:16:42 klogd: * scsi_register: usb-storage-0,
      > <44>Oct 15 19:16:42 klogd: * scsi_reg, hostno:0 prot is 50
      > <44>Oct 15 19:16:42 klogd: * scsi_reg, retval->host_no:0
      > <46>Oct 15 19:16:42 klogd: scsi0 : SCSI emulation for USB Mass Storage
      > devices
      > <44>Oct 15 19:16:42 klogd: ! scan_scsis
      > <44>Oct 15 19:16:42 klogd: *** 50
      > <44>Oct 15 19:16:42 klogd: is removable disk
      > <44>Oct 15 19:16:42 klogd: Vendor: SIIG Model: CompactFlash Car
      > Rev: 0113
      > <44>Oct 15 19:16:42 klogd: Type: Direct-Access
      > ANSI SCSI revision: 02
      > <44>Oct 15 19:16:42 klogd: the host no is 0
      > <44>Oct 15 19:16:42 klogd: * sd_attach:1
      > <44>Oct 15 19:16:42 klogd: Attached scsi removable disk sdb at scsi0,
      > channel 0, id 0, lun 0
      > <44>Oct 15 19:16:42 klogd: SCSI device sdb: 15745 512-byte hdwr
      > sectors (8 MB)
      > <44>Oct 15 19:16:42 klogd: sdb: test WP failed, assume Write Enabled
      > <46>Oct 15 19:16:42 klogd: sdb1
      > <47>Oct 15 19:16:42 klogd: WARNING: USB Mass Storage data integrity
      > not assured
      > <47>Oct 15 19:16:42 klogd: USB Mass Storage device found at 2
      > <46>Oct 15 19:16:42 klogd: EXT3 FS 2.4-0.9.19, 19 August 2002 on
      > sd(8,1), internal journal
      >
      > Hope this helps,
      >
      > Albert
    • Show all 3 messages in this topic