Re: Help Build My First Still, Drawing attached
- To answer #1 & # 3. You can simply drill a hole and get a rubber grommet from a hardware store, or get fancy and use brass compression fittings. To fit the compression to a pot lid you can get a coupler and washers . The copper goes into one side of the coupler , then the middle of it looks like a nut, you put washers against the nut , this goes on the top, (outside )of the pot lid.On the inside of the pot lid you will have the threaded other end sticking out. On this you use more washers and then the other nut part of the coupler, just tighten it up against the washers to squeeze against the pot lid.This will only work if you are using copper line of the size that they have compression fittings for of course.
--- In email@example.com, "shark_killah" <eddiegnz1@...> wrote:
> please see the drawing of my rough plan for my first still.
> 1. Question 1: how do I attach copper pipe or tube to the lid of the
> SS stock pot ?
> 2. Question 2: what size diameter should the pipe be from the main
> boiler to the thumper?
> 3. Question 3: the thumper is also a SS stock pot, should how should
> I attach the pipe from the boiler to the thumper?
> 4. question 4: how do I attach the tube from the thumper to the worm?
> 5. question 5: what size diameter should the tube be that attaches to
> lid on the thumper which goes to the worm?
> Question 6: what suggestions do you have based on my drawing.
> The drawing might clarify my questions.
> thank you brothers !