Loading ...
Sorry, an error occurred while loading the content.

43441Re: [new_distillers] Re: Noobie thoughts

Expand Messages
  • Chuck Todd
    Mar 1, 2013
    • 0 Attachment
      Thanks for the update

      Let me know how it goes
      Sometimes things dont go as planned
      I will put my Help on hold until we get this worked out.

      I already gave my panel builder a 1000 dollar deposit so i would not lose him to another job

      Keep me posted now that you know what happened it should not ne too hard to fix


      Sent from my Motorola ATRIX™ 4G on AT&T

      -----Original message-----
      From: cnapier@...
      Fri, Mar 1, 2013 21:39:45 GMT+00:00
      Re: [new_distillers] Re: Noobie thoughts


      My plate handles my 2 gallon just fine.....

      Figure if I go up...........3 or 4 gallon.......

      If would take forever.....


      From: RLB <last2blast@...>
      To: "new_distillers@yahoogroups.com" <new_distillers@yahoogroups.com>
      Sent: Fri, March 1, 2013 1:38:29 PM
      Subject: Re: [new_distillers] Re: Noobie thoughts


      My 220 V, 30 A range has coils, but my hotplate burner is solid.  That should allow for better heat transfer than my range, and it might reduce distillation time, which should save money in the long run.


      From: Mike <mikeraphael2000@...>
      To: "new_distillers@yahoogroups.com" <new_distillers@yahoogroups.com>
      Sent: Friday, March 1, 2013 12:01 PM
      Subject: Re: [new_distillers] Re: Noobie thoughts

      Possibly higher due to more amps used

      Sent from my iPhone

      On Mar 1, 2013, at 9:21 AM, Fredrick Lee <fredrick@...> wrote:

      The amount of energy to run the still will not change. Your electric bill will probably remain the same. 

      On Feb 28, 2013, at 11:18 PM, RLB <last2blast@...> wrote:

      I have a hot plate that cycles, but it was only used to melt solder.  Guess it's time to test it with my 2.5 gal pot still.  Hot plate is 110 V, whereas my kitchen range is 220v.  I should be able to cut my electric bill by using a hot plate if it works well.  Thanks Bob!

      Has anyone thought of using a blower with ethanol or methanol to heat a still such as in oil furnace like setup? 


    • Show all 19 messages in this topic