Loading ...
Sorry, an error occurred while loading the content.

Topics List

Bansuri Project

(33)
Hey Oldmoore, If you look down this message thread, Moosewind Mike explains just intonation (JI) - a tuning in which to note intervals are based on simple
edwardkort
33
posts
Apr 21

TSH location?

(6)
Hi Ron, Sense I was the one who brought this up, maybe I should answer it the best way I can, then have Mike Jones clarify anything I might miss or leave in a
Kerrye Raven
6
posts
Apr 8

Introduction

(96)
I like Joey's reply to our group and I'd like to add to it now that I've built both chiseled flutes and router'd flutes over the past decade. My experience
Kerrye Raven
96
posts
Apr 6

Changes in fundamental when tuning

(8)
The 4th flute I ever made, about April 2010, was a Sycamore E4 NAF. It had a reverse grain in the bore that stood up like the hair on a dog's back. I left it
David Wilson
8
posts
Mar 19

Introducing: err...Me

(11)
Flat faced and immediately under the SAC exit is nearly always best. What you are talking about is caused by the way makers use a round box bit to shape the
Michael Jones
11
posts
Mar 17

TSH Wedges - my results

(10)
Thanks Mike, I look forward to meeting you at the flute circle in the future. I'm stuck in the Heights now truck problems Karl
octatawodi
10
posts
Mar 11

Elderberry flutes

(17)
I harvest my own. If you contact some nurseries, they may be able to tell you if anyone that lives close has any. Also contact the American Bamboo Society. I
Michael Jones
17
posts
Mar 9

Flute finishing - spray

(6)
Crystalac, is a water based finish, no odor, and it drys as quickly as shellac. It has the lowest toxicity of any finish I have found and was designed for toys
grazinghorse@gmail.com
6
posts
Mar 9

A bit disappointed

(8)
I am not really sure. I have seen some professional flutists using a seven hole flute. I had presumed that this aided in tuning the notes above the octave.
STANLEY L LOFTNESS
8
posts
Mar 7

hole burning

(3)
I use an electric wood burning tool. I have several attachments of varying diameters. Generally, I will use a drill press to gradually enlarge the hole until
andre1750
3
posts
Feb 25
View First Topic Go to View Last Topic