Loading ...
Sorry, an error occurred while loading the content.

Logan 10" for sale

Expand Messages
  • Lance
    Complete except for steady rests. Has QCGB, 5 3 jaw and 6 4 jaw Contact me off-list for the seller s phone number. Unit located near Buffalo, NY USA lance
    Message 1 of 3 , Jun 2, 2009
    • 0 Attachment
      Complete except for steady rests.
      Has QCGB, 5" 3 jaw and 6" 4 jaw

      Contact me off-list for the seller's phone number.
      Unit located near Buffalo, NY USA

      lance
      ++++
    • drpshops@yahoo.com
      Hello Pat This is my view on it, the flywheel should turn at a good RPM  to work good. F  Then you would need some reduction to get the spindle speed you
      Message 2 of 3 , Jun 2, 2009
      • 0 Attachment
        Hello Pat
        This is my view on it, the flywheel should turn at a good RPM
         to work good. F
         Then you would need some reduction to get the spindle speed you
         want.

        Deep Run Portage
        Back Shop
        " The Lizard Works"

        --- On Tue, 6/2/09, Pat Delany <rigmatch@...> wrote:


        From: Pat Delany <rigmatch@...>
        Subject: [multimachine] A bike powered MM idea
        To: multimachine@yahoogroups.com
        Date: Tuesday, June 2, 2009, 11:50 AM








        A picture is in a new folder "1 Bike powered MM".

        Explanation:
        The machine would have only 2 speeds (slow and very slow) that are selected by moving a chain from 1 set of sprockets to another.

        The brake drum flywheel would be mounted on a shortened axle shaft that would run on a ball bearing in the cylinder bore and be supported near the flywheel by a cast ZA-27 bushing mounted on a plate on the oil pan surface.

        The "flywheel" (that could be filled with concrete) would mount:
        The "high" speed sprocket,
        A brake band,
        A pulley or sprocket that would connect to a 10 speed bike hub.

        I'm going to write to Tony @ lathes.co.uk and try to find out slow "triple" geared, pedal powered lathes turned when they made heavy cuts. (see Brittania mod. 18)

        The whole setup could be made from junk and ZA-27 castings.

        Your input really needed here!

        Pat
      Your message has been successfully submitted and would be delivered to recipients shortly.