Loading ...
Sorry, an error occurred while loading the content.

Re: [multimachine] What table should I get ??

Expand Messages
  • Mike Delany
    The more travel the better. One thing that you might look for is a used American X Y table. I found a Palmgren that is very tight listed in the paper. Cost
    Message 1 of 4 , Apr 10, 2005
    • 0 Attachment
      The more travel the better. One thing that you might look for is a used
      American X Y table. I found a Palmgren that is very tight listed in the
      paper. Cost less than the shipping on the Enco table and should last
      twice as long.

      Mike


      On Mon, 11 Apr 2005, joe wrote:

      >
      > Hello,
      > Anyone care to jump in and comment about what cross slide table to
      > get ??
      > Enco has the small table (#201-2826) on sale for $68.95. 12 inch
      > long, 5 and 1/2
      > inches wide, 8 inch longitudinal travel, 5 inch cross travel. The
      > bigger table is $119.95
      > on sale (#201-2536) 18.5 inches long, 6 inches wide, 11 inch
      > longitudinal travel, 7.5
      > inch cross travel.
      > I don't want to be too cheap, but I am trying to do this on a budget.
      > Pros and cons ?
      > Thanks, Joe
      >
      >
      >
      >
      > ____________________________________________________________________________________________________________________________________________________________
      > Yahoo! Groups Links
      > * To visit your group on the web, go to:
      > http://groups.yahoo.com/group/multimachine/
      >  
      > * To unsubscribe from this group, send an email to:
      > multimachine-unsubscribe@yahoogroups.com
      >  
      > * Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
      >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.