Loading ...
Sorry, an error occurred while loading the content.

Re: [multimachine] Re: cw/ccw rotation help

Expand Messages
  • HB
    Here s one setup to adapt a CCW motor to a CW propeller.
    Message 1 of 21 , May 7, 2013
    • 0 Attachment
      Here's one setup to adapt a CCW motor to a CW propeller.

      http://www.boatdesign.net/forums/attachments/diy-marinizing/36541d1256447440-angle-engine-longtail-straight-shaft-mud-motor-1ajetski-078.jpg




      From: Pat Delany <rigmatch@...>
      To: "multimachine@yahoogroups.com" <multimachine@yahoogroups.com>
      Sent: Sunday, May 5, 2013 9:46 AM
      Subject: Re: [multimachine] Re: cw/ccw rotation help

       
      Been thinking about this also. It would take a pillow block or 2 but Jeremmy uses them on other tools so I know they are available. The second sprocket could be a m/c one that has been bushed and bored to fit the shaft. A huge advantage is that almost any small engine could be used. The engine would have to be offset but this should not be a big deal. Repairs should be simple, an important point on a lake 200 miles wide.

      Pat


      From: pokerbacken <no_reply@yahoogroups.com>
      To: multimachine@yahoogroups.com
      Sent: Sunday, May 5, 2013 10:57 AM
      Subject: [multimachine] Re: cw/ccw rotation help

       
      one thing i come to think of, why not use the existing chain drive and just attach a sprocket to the shaft of the motor, that way it can be switched in minutes if it is discovered that it rotates wrong way, just rotate the motor 180 on the baseplate and propeller now goes right way.
      flipping the motor is different from flipping the propeller, by the way.





    Your message has been successfully submitted and would be delivered to recipients shortly.