18053Re: [multimachine] Developing country "Cole" drill
- Jul 15, 2014On 07/15/2014 07:55 PM, Lance Eggleston gbof@... [multimachine] wrote:
Would this require two screws?One to apply pressure to the piece, and one to turn the drill
Actually, the one screw in the "C" clamp. It applies pressure while the drill simply turns -- no screw needed to turn the drill, just a shaft and a bearing.
"A word to the wise ain't necessary - it's the stupid ones that need the advice."
- << Previous post in topic Next post in topic >>