Loading ...
Sorry, an error occurred while loading the content.

17993RE: Magnetic chuck plans posted to files

Expand Messages
  • pokerbacken
    Feb 19, 2014
    • 0 Attachment
      just be careful, most modern (rather, later than mid-late 80's) enamelled wire is the "easy solder" version that would short circuit if babbitt was poured over it (enamel is mostly low melting point plastic), I would pour a base of babbit then a 20mm steel plate and on that stack the wound laminations(wound on T shaped bars with the ends of the T crossbar made from 1mm brass strips silver soldered in place
    • Show all 13 messages in this topic