Loading ...
Sorry, an error occurred while loading the content.

Re: "Rotary" switch

Expand Messages
  • grengerx
    ... That`s the same I`m following,but like you ,those schematics give me a headache.I did wire the switch after I straightened the center metal post(it was
    Message 1 of 9 , Mar 1, 2013
    • 0 Attachment
      --- In mlathemods@yahoogroups.com, Robert Francis <bobf0648@...> wrote:
      >
      > Sorry I didn't specify, this is the drawing from the owners manual for
      > the lathe.
      >
      > European diagrams are really hard for me to follow, but I'm pretty sure
      > it's correct for single phase power.
      >
      > Bob
      >
      That`s the same I`m following,but like you ,those schematics give me a headache.I did wire the switch after I straightened the center metal post(it was bent)and it felt it was ok ,but I didn`t see the disconnected white wire until it was too late to note it`s position on the 12 posts switch.
    Your message has been successfully submitted and would be delivered to recipients shortly.