Loading ...
Sorry, an error occurred while loading the content.

3148Re: Hi, can someone help with the correct wiring of a lathe motor

Expand Messages
  • sheena_r_woods
    May 15, 2010
    • 0 Attachment
      thanks very much it looks bang on actually cheers :)

      --- In mlathemods@yahoogroups.com, Malcolm Parker-Lisberg <mparkerlisberg@...> wrote:
      >
      > Sheena
      >
      > Yahoo butchered the link again.
      >
      > http://www.st.com/stonline/products/promlit/pdf/brmotor-0503.pdf
      >
      > It inserted a space before the .com 
      > a space before products
      > a space before promlit
      > a space before brmotor
      > and a space before pdf at the end
      >
      > I don't suffer from insanity I enjoy it!
      >
      > --- On Fri, 5/14/10, Malcolm Parker-Lisberg <mparkerlisberg@...> wrote:
      >
      > From: Malcolm Parker-Lisberg <mparkerlisberg@...>
      > Subject: Re: [mlathemods] Re: Hi, can someone help with the correct wiring of a lathe motor
      > To: mlathemods@yahoogroups.com
      > Date: Friday, May 14, 2010, 2:40 PM
      >
      >
      >
      >
      >
      >
      >
      >  
      >
      >
      >
      >
      >
      >
      >
      >
      >
      > Sheena
      >
      > Take a look at the DC universal motor drive circuit on page 5 of this link:
      > <http://www.st. com/stonline/ products/ promlit/pdf/ brmotor-0503. pdf>
      > I suspect that this is very similar to the circuit used on your board.
      >
      > Malcolm
      >
      > I don't suffer from insanity I enjoy it!
      >
      > --- On Fri, 5/14/10, sheena_r_woods <sheena_r_woods@ yahoo.co. uk> wrote:
      >
      > From: sheena_r_woods <sheena_r_woods@ yahoo.co. uk>
      > Subject: [mlathemods] Re: Hi, can someone help with the correct wiring of a lathe motor
      > To: mlathemods@yahoogro ups.com
      > Date: Friday, May 14, 2010, 11:28 AM
      >
      >
      >
      >
      >
      >
      >
      >  
      >
      >
      >
      >
      >
      >
      >
      >
      >
      >
      > --- In mlathemods@yahoogro ups.com, "sheena_r_woods" <sheena_r_woods@ ...> wrote:
      >
      > >
      >
      > > hi, I have a single phase lathe motor and a circuit board and a flex but am unsure as to how to solder them together as there are no markings I will post pictures as soon as I can. the circuit board has three resistors a diode a pot a capacitor a mosfet and a switch which should connect to a flex at one end and a single phase 230v motor at the other.
      >
      > >
      >
      > pictures
      >
      >
      >
      > album is called
      >
      > motor and circuit board
      >
      >
      >
      > http://groups. yahoo.com/ group/mlathemods /photos/album/ 900595769/ pic/list
      >
      >
      >
      > any help much appreciated
      >
    • Show all 5 messages in this topic