Loading ...
Sorry, an error occurred while loading the content.

1588RE: [mlathemods] Re: live center woes

Expand Messages
  • David Lee
    May 1, 2006
      A live center turns with the work. A dead center is in the tailstock. A
      turning center turns with the work and is mounted in the tailstock.

      David Lee

      ----------------------------------------------------------------------------
      ----

      -----Original Message-----
      From: mlathemods@yahoogroups.com [mailto:mlathemods@yahoogroups.com]On
      Behalf Of ndhr23a
      Sent: Saturday, April 29, 2006 11:01 AM
      To: mlathemods@yahoogroups.com
      Subject: [mlathemods] Re: live center woes


      The length of the taper in the small lathe tailstock is smaller than
      the normal Morse taper and many commercial tapers will "hit bottom'
      before they seat, especially ones with tangs on them. Also, the
      tailstock is designed to push out or eject the taper when it is fully
      retracted. Try extending your tailstock quill some to see if the taper
      will now seat.


      [Non-text portions of this message have been removed]
    • Show all 22 messages in this topic