Loading ...
Sorry, an error occurred while loading the content.

Topics List

Newbie says hello

(13)
Thanks for pointing these things markhnx, "That said I think a lot of you guys are thinking of a RF-30 or some even mentioned RF-45. the 25 only weighs in at
jdkmlw
13
posts
1:21 PM

head elevation motor

(4)
Al and Pete, The easiest, most available way of removing the shipping grease I have found is WD-40 and a brush and rag. It is easy to acquire, and the nozzle
Carl Hollopeter
4
posts
5:35 AM

new article: Reducing X and Y Axis Backlash on a RF-30 Mill/Drill

(3)
Malcolm, I did run fail to mention in the article that I ran the full range before doing my happy dance. I'll correct that oversight in the next version.
Rick - yahoo
3
posts
5:18 PM

new article: Reducing Quill Backlash and Setting Z Axis Gain on a RF

(22)
Yes Rick the DTI would, but it shows its deflection over a 1" scale (that quiver you see on the needle) where the laser will be at several feet. If I am
markknx
22
posts
Apr 18

what is the risk?

(55)
Mark, I have never known you to have boring projects! No doubt you will figure this crazy machine out... Rick ... From: MILL_DRILL@yahoogroups.com
Rick - yahoo
55
posts
Apr 12

preliminary results of removing rack and pinion backlash from the Z

(3)
Ian, Glad you are joining into the discussion. I put a finger DTI on my quill with the finger on the table. By gently lifting and pushing down with my fingers,
Rick - yahoo
3
posts
Apr 12

DRO

(64)
Jerry I believe the price list is current. Email Echo direct for a quote. Activity was inked to group buys for the Sumatech DRO so goes in waves. Malcolm I
Malcolm Parker-Lisberg
64
posts
Apr 9

6" vise for a RF-30 - which one? (Without breaking the bank!)

(23)
I cut the rear flange (gutter?) off my 6" clone. Works great, should have done it sooner. Sent from my Verizon Wireless 4G LTE smartphone ... From:
vandal968
23
posts
Mar 31

Q Max punches

(4)
I've had reasonable life with Ruko punches from Germany. Automation Direct sells them quite reasonably. The bolts go bad before the punches. Regards cww On
Curt Wuollet
4
posts
Mar 28

Fix for yahoo photo jump.

(3)
Thank you very much Mark, this annoyed me so much I stopped looking at the pics section
jdkmlw
3
posts
Mar 27

RF 31/Warco Major Questions

(17)
Pity about the big house… I buy from Wealden too Stuart - the stuff is not cheap but seems to be of decent quality, it's a wide range in one place, and the
ondablade
17
posts
Mar 20

any steel will not do

(8)
from your magnetic description, it would appear to be series 400.   From: "Jerry Durand jdurand@interstellar.com [MILL_DRILL]"
Chris Demers
8
posts
Mar 20

Drawbar question

(5)
I just slid a piece of rubber hose on it. Centers it and helps with the general racket level. Regards cww
Curt Wuollet
5
posts
Mar 16

Using double ended endmills

(10)
The draw bar should not be a issue its back far enough so you can still drill the holder GP On Tuesday, March 10, 2015 4:59 PM, "paulguenter@att.net
paulguenter@att.net
10
posts
Mar 10
View First Topic Go to View Last Topic
Loading 1 - 15 of total 15 topics