Loading ...
Sorry, an error occurred while loading the content.

Tiny Endmills - Job Complete!

Expand Messages
  • Ray Livingston
    Wasn t really too hard after all! Lots of air, to keep the chips out of the way, max DOC of 0.040 , and feed of 1.5 IPM. I did three pieces (a total of almost
    Message 1 of 1 , Jul 30, 2008
    • 0 Attachment
      Wasn't really too hard after all! Lots of air, to keep the chips out
      of the way, max DOC of 0.040", and feed of 1.5 IPM. I did three pieces
      (a total of almost 100" length) of 1/16" wide by 1/16" deep with a
      single 1/16" endmill!

      Regards,
      Ray L.
    Your message has been successfully submitted and would be delivered to recipients shortly.