Loading ...
Sorry, an error occurred while loading the content.

5189Re: [mill_drill] Re: Quill DRO ?

Expand Messages
  • Owen Lloyd
    Feb 11, 2003
    • 0 Attachment
      Hank,
      Is it physically too long to mount? If not, I'd use it as is. Put the extra length at the top. If it is typical of DRO units I've seen you can zero it at any point making the relative position of the shaft un important [unless I'm over looking some thing here.]
      Just my .02
      Owen
       
      ----- Original Message -----
      Sent: Tuesday, February 11, 2003 2:18 PM
      Subject: Re: [mill_drill] Re: Quill DRO ?

      it's too long, by about 2".
      Hank
    • Show all 13 messages in this topic