Loading ...
Sorry, an error occurred while loading the content.

36124Re: [MILL_DRILL] how is that done question

Expand Messages
  • Terry Coombs
    Jul 23, 2014
      mayo3013@... [MILL_DRILL] wrote:
      > I don't think it,s a blind hole. I think this because the hand? that
      > comes up to move the cylinderhas to come through from the back. I'm
      > thinking if you take the side plate off you will see the slot goes
      > through. then it may have been done on a horizontal mill and then
      > broached or filed to cleen up the ends.
      > Mark

      There is no sideplate , this is a solid piece of steel .

    • Show all 17 messages in this topic