Loading ...
Sorry, an error occurred while loading the content.

32095Re: [mill_drill] Bit life, another aspect

Expand Messages
  • Corey Renner
    Nov 27, 2012
      your theory is correct, and under CNC it is pretty easy to take advantage of this effect, however, when manual milling you normally do not have very precise control of your feed-rate and the efficiency gains made by engaging more of the tool are usually undone by the chatter&vibration caused by deep cuts and imprecise feeds.


      On Tue, Nov 27, 2012 at 1:13 AM, Goran Hosinsky <hosinsky@...> wrote:

       the idea being that the wear of the
      cutting edge is a function of the number of cuts, a few heavy cuts wears
      the edges less than many light ones. The mill is manual.

      Am I right thinking this?

      Goran, Canary Islands

    • Show all 26 messages in this topic