Loading ...
Sorry, an error occurred while loading the content.

32093Re: Bit life, another aspect

Expand Messages
  • carlmciver
    Nov 27, 2012
    • 0 Attachment
      I've only been paying peripheral attention to this thread, so if I missed the suggestion previously, I apologize. Have you looked at roughing end mills for first pass removal of lots of metal? These things are a real time saver for me.

      --- In mill_drill@yahoogroups.com, Robert Broughton <r.broughton@...> wrote:
      > Before you get to max depth of cut, you need to look at both rigidity and power at the spindle (it is about 50 to 70% of the motor's rated power) to make sure you can remove the amount of material for your setup. Then you will need to look at the material you are cutting. As part of the rigidity, you will need to use the largest diameter end mill you can use for the project (and that your machine can still drive) because the larger the diameter, the more rigid the tool bit will be. Another factor is the type of end mill you are using as HSS is able to deflect more than Carbide. Finally, the greater the depth of cut, the greater the end mill deflection to the point that the end mill will finally break.
      > Being manual control, you probably want to err on the side of caution as you can inadvertently feed the machine faster than you were expecting.
      > Hopefully this gives you an idea of what you are looking at in your question.
      > Bob
      > ________________________________
      > From: Goran Hosinsky <hosinsky@...>
      > To: mill_drill@yahoogroups.com
      > Cc: hosinsky@...
      > Sent: Tuesday, November 27, 2012 1:13 AM
      > Subject: [mill_drill] Bit life, another aspect
      > Hello,
      > I have to remove rather a lot of steel for a couple of toolholders. I
      > have no facility for sharpen endmills, getting new ones takes time as I
      > have to order from abroad. I am thinking that the best policy is to take
      > as deep cuts as my mill permits, the idea being that the wear of the
      > cutting edge is a function of the number of cuts, a few heavy cuts wears
      > the edges less than many light ones. The mill is manual.
      > Am I right thinking this?
      > Goran, Canary Islands
    • Show all 26 messages in this topic