Loading ...
Sorry, an error occurred while loading the content.

32080Bit life, another aspect

Expand Messages
  • Goran Hosinsky
    Nov 27, 2012
    • 0 Attachment
      Hello,

      I have to remove rather a lot of steel for a couple of toolholders. I
      have no facility for sharpen endmills, getting new ones takes time as I
      have to order from abroad. I am thinking that the best policy is to take
      as deep cuts as my mill permits, the idea being that the wear of the
      cutting edge is a function of the number of cuts, a few heavy cuts wears
      the edges less than many light ones. The mill is manual.

      Am I right thinking this?

      Goran, Canary Islands
    • Show all 26 messages in this topic