18772Re: [mill_drill] Plug Removal
- Dec 5, 2007Finish the cut from the back side, then most of the plug is still sticking out when you finish.
Or, drill opposing small holes on the inside periphery of the circle beforehand, and grab the plug with needle nose pliers in the holes.
Or, plug all but one hole with your fingers and apply the air gun to the open hole.
Or, spin the drill in reverse, so the plug unwinds off the pilot drill
rexarinoOn Dec 4, 2007 6:39 PM, roylpopecharternet < rlpope@...> wrote:
Anyone have a good method for removing the plug from a bi-metal hole
saw after cutting a hole in steel???
I'm not too happy trying to jab them out with a small screwdriver.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
- << Previous post in topic Next post in topic >>