Loading ...
Sorry, an error occurred while loading the content.

13884Re: [mill_drill] Re: DRO from Spokane on the way

Expand Messages
  • Glenn N
    Jan 21, 2006
    • 0 Attachment
      Thanks Mike,
      That is the direction I am heading too.  Just wanted to be sure you hadn't had some "startling revelation" that would save some riggin.
      ----- Original Message -----
      From: mikaelc
      Sent: Saturday, January 21, 2006 7:28 PM
      Subject: RE: [mill_drill] Re: DRO from Spokane on the way


      Never did. I have the schematic for the 1.5 volt power supply from the other units, and so when I get some time I’m going to build up a unit on a daughter board, cut some traces on the main board and wire it in. I’ll post pictures when I get it done.







      -----Original Message-----
      From: mill_drill@yahoogroups.com [mailto:mill_drill@yahoogroups.com] On Behalf Of Glenn N
      Sent: Saturday, January 21, 2006 8:20 PM
      To: mill_drill@yahoogroups.com
      Subject: Re: [mill_drill] Re: DRO from Spokane on the way



      Did you ever hear back on prints or parts?


      ----- Original Message -----

      From: miker557

      Sent: Thursday, January 05, 2006 2:31 PM

      Subject: [mill_drill] Re: DRO from Spokane on the way


      There's a name on the circuit board, "Guanglu". I looked them up on
      Google, it's a company in China that makes calipers and measuring
      devices (big surprise). Not sure if they build the whole thing
      there, or simply supply the board to Shars, as this particular unit
      is not listed on their web page. I did leave them an e-mail (Guanglu
      and Shars both) asking them about the missing components on the
      board, and the possibility of finding out what's supposed to go
      there (if anything). I'll let you know what (if anything) they say.


      > My display is the same.  They just didn't hook up the lights or
      perhaps didn't install the components for running the lights.  There
      are a lot of unfilled holes in there :)
      > Glenn

    • Show all 19 messages in this topic