RE: [midatlanticretro] Two months until TCF...
> Hi everyone... so there are two months until TCF... how are yourBeen meaning to reply to this for a while...
> efforts to get everything in working order?
I have fitted a newer switcher PS in my OSI C4P-MF. This is due to
the problem that the computer currently draws 7.2 amps and the existing
(factory original) PS was a pair of linear 3 amp supplies, Deltron
QPS-1's. OSI claimed that they were 3.5 amp supplies, but the original
Deltron documentation says 3. The computer will run with the original
supplies, but they quickly overheat. If left operating for more than
about 30 minutes, the solder on the supplies will start to flow. I am
quite pleased with this modification. I have been very careful and can
reverse it (restore to factory original condition) with about 15 minutes
of screwdriver action and about two minutes with a soldering iron. The
soldering is required because OSI always soldered their AC connections.
The modification was a challenge because the metal frames of the original
PS's are integral to the structure of the computer. Anyway, I have done
several tests, having the computer operating for up to 18 hours with no
For my Sol, I usually run CP/M on it. Jim Battle has several programs on
his web site that I would like to be able to easily run. They were
originally loaded from cassette tape and are stored in "ent" files, the
ASCII data stream you would usually see coming in over the cassette port.
They are also "ORG'd" at address 0x0000 which conflicts with CP/M. I am
attempting to write a program that will load one of these files into memory,
converting the ASCII to binary and buffering any writes to the first 512
bytes of memory out of the way until the entire file is read (after that,
we don't need CP/M any more) then move the block where it belongs and
jump to it.
One other thing I'd like to do is to buy and fit a new CRT into my ADM-3A
(which I use as a terminal for several of my S-100 boxes). It currently
has a good bit of screen burn and my secondary ADM-3A has the dreaded CRT
mold problem, recently discussed on classiccmp.