Loading ...
Sorry, an error occurred while loading the content.
 

Re: [metalshapers] Re: Pexto #622 Beader

Expand Messages
  • gordon bartlett
    Hi Barry The pin is 1/8 and in a step of the shaft .I ll have to dig around for a bolt small enough to go inside . Thanks for suggestion GordonB ... From:
    Message 1 of 6 , Jan 1, 2010
    Hi Barry
                The pin is 1/8" and in a step of the shaft .I'll have to dig around for a  bolt small enough to go inside .
     Thanks for suggestion
    GordonB 
     
    ----- Original Message -----
    Sent: Wednesday, December 30, 2009 9:09 PM
    Subject: Re: [metalshapers] Re: Pexto #622 Beader

     

    Gordon
                Do  you have a tig machine  or  mig  with  ss   rod     wire?   weld  a   short length  of  ss  thred  rod  to  the  pin   put  a  deep  socket  over  it   ...  nut  and  washer  and  you  have  a  broken  pin  puller...... .........  Barry L

  • rnaida1043@aol.com
    Drill from the other side and drive it out. Then use a roll pin to replace it protruding on one side and flush on the other. Or grind it flush and drill a new
    Message 2 of 6 , Jan 1, 2010
      Drill from the other side and drive it out.
      Then use a roll pin to replace it protruding  on one side and flush on the other.
       
      Or grind it flush and drill a new one 90 or 180 or 270 around.
       
      Ron Naida


      -----Original Message-----
      From: gordon bartlett <stingshp@...>
      To: metalshapers@yahoogroups.com
      Sent: Fri, Jan 1, 2010 6:42 pm
      Subject: Re: [metalshapers] Re: Pexto #622 Beader [1 Attachment]

       
      [Attachment(s) from gordon bartlett included below]
      Hi Barry
                  The pin is 1/8" and in a step of the shaft .I'll have to dig around for a  bolt small enough to go inside .
       Thanks for suggestion
      GordonB 
       
      ----- Original Message -----
      Sent: Wednesday, December 30, 2009 9:09 PM
      Subject: Re: [metalshapers] Re: Pexto #622 Beader

       
      Gordon
                  Do  you have a tig machine  or  mig  with  ss   rod     wire?   weld  a   short length  of  ss  thred  rod  to  the  pin   put  a  deep  socket  over  it   ...  nut  and  washer  and  you  have  a  broken  pin  puller...... .........  Barry L
    Your message has been successfully submitted and would be delivered to recipients shortly.