RE: [MedievalSawdust] Re: Recent project....
The only way I can see a scraper ripping out long grain is if you take a too-heavy cut with the edge square on. Have you tried holding the edge at an angle to the axis of the work to achieve a shearing cut? Done properly, this will produce fine wispy shavings and a near-flawless surface. There’s a lot of good demonstration videos available from Robert Sorby at http://www.robert-sorby.co.uk/movie-clips.htm.
Having a bowl phase in Caid
From: firstname.lastname@example.org [mailto: email@example.com ] On Behalf Of Barekr Silfri
Sent: Tuesday, November 07, 2006 8:05 PM
Subject: RE: [MedievalSawdust] Re: Recent project....
yeah my bowl gouge is kinda rounded along the bottom, my roughing gouge makes a more U-shape chisel and I used the top corner of the U. my scraper did awesome on the end grain i.e. the bottom of the cups, but when I tried to shave the sides smooth it shredded the sides rather than carving it away. Before you ask I did sharpen the scraper a few times as I thought that was my problem but it didn't change the outcome.