Loading ...
Sorry, an error occurred while loading the content.

Re: turning parts AFTER center drilling

Expand Messages
  • Ron
    I tried to describe this, but they say a picture is worth a 100 words, so a video must fill a book. I shot this with my little Olympus camera, and
    Message 1 of 7 , Feb 18, 2012
    • 0 Attachment
      I tried to describe this, but they say a picture is worth a 100 words, so a video must fill a book. I shot this with my little Olympus camera, and unfortunately, it came out quite small, but I think you'll get the idea.

      http://youtu.be/CVxuyQHwG6g

      Bayard

      --- In medievalsawdust@yahoogroups.com, Jim Hart <conalohairt@...> wrote:
      >
      > My first try at turning parts after center drilling went....ok
      >
      > http://i147.photobucket.com/albums/r295/ConalOhAirt/griptest1.jpg
      >
      > I turned some plugs and stuck them in the holes I center drilled and
      > proceeded to turn the part.
      > The plugs are tapered so they kinf of jam into the hole...
      >
      > I got lots of wobble through out the turning process... the plugs shifted
      > their axis during the
      > turning..... Not enough to ruin the part but enough that if was annoying.
      >
      > Suggestions?
      >
      > --
      > Jim Hart
      > Conal OhAirt
      >
      > Aude Aliquid Digmun - *dare something worthy*
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.