Loading ...
Sorry, an error occurred while loading the content.
 

Re: [MedievalSawdust] SCA 'period' beginners woodturning projects?

Expand Messages
  • Lynda Fjellman
    I made lace bobbins on my first wood lathe. Ilaria bowls and mugs were my first attempts on a lathe... Bear
    Message 1 of 6 , Apr 7, 2011
      I made lace bobbins on my first wood lathe.
      Ilaria


       

      bowls and mugs were my first attempts on a lathe...


      Bear
    • Ralph
      ... What tools do you have? My opinion, start with spindles. Spindle work is the easiest place to start. My wife is really just starting and has made some
      Message 2 of 6 , Apr 8, 2011
        --- In medievalsawdust@yahoogroups.com, Jim Hart <conalohairt@...> wrote:
        >
        > Got my lathe tools and the faceplate today.
        >
        > Looking for some suggestions for beginners projects to try that are period
        > but still in the beginning turner realm of possibility.....
        >
        > The spur centers are back ordered....
        >
        What tools do you have?

        My opinion, start with spindles. Spindle work is the easiest place to start. My wife is really just starting and has made some all-wood awls and some nostepinne (knitting and spinning thing)

        Face-plate work can require tools that you don't always get in "starter" sets.
        (CAPS on purpose)
        THE FULL NAME OF THE ROUGHING GOUGE IS SPINDLE ROUGHING GOUGE. It should not be used for face-plate work, and neither should a Skew. I have seen people with many years of experience use both, but most of us don't have that knowledge.

        If you haven't seen "Woodturning A Foundation Course" by Keith Rowley, get it, it's the -best- book out there

        Ralg
        AnTir
      • Ron
        As I said in an earlier post, if you have both a dead and live center already, you can easily drive spindles, and its much safer than using s spur drive -
        Message 3 of 6 , Apr 10, 2011
          As I said in an earlier post, if you have both a dead and live center already, you can easily drive spindles, and its much safer than using s spur drive - watch this video to see what I mean:

          http://www.youtube.com/watch?v=CmCNdS4-GeE

          How big a faceplate? Here's another video showing someone turning a goblet. He's using a chuck to hold the block from the end but you could do the same with a faceplate as long as you waste enough wood at that end to clear your screws.

          http://www.youtube.com/watch?v=FXNNbS4wC6w

          Note how he mostly turns downhill on the outside, but hollows our from the center to the rim - this keeps the wood you cut supported by the fibers behind it.

          Bayard

          --- In medievalsawdust@yahoogroups.com, Jim Hart <conalohairt@...> wrote:
          >
          > Got my lathe tools and the faceplate today.
          >
          > Looking for some suggestions for beginners projects to try that are period
          > but still in the beginning turner realm of possibility.....
          >
          > The spur centers are back ordered....
          >
          >
          >
          > --
          > Jim Hart
          > Conal OhAirt
          >
          > Aude Aliquid Digmun - *dare something worthy*
          >
        Your message has been successfully submitted and would be delivered to recipients shortly.