Sorry, an error occurred while loading the content.
...but I was mistaken.....Baron Conal O'hAirt / Jim Hart
That is.... until I fixed the mistake I thought I made.... I did it correctly
and then thought.... 'That's not right', instead of checking I just
flipped the part over and did it wrong....
64 holes in 64 foldstool legs each 2" off where it should have been.
Wrong end of the piece against the stop on the drill press.
@#$#@^& (*&^%$#$%^ @#$#^^ &% *(^% %@ !!!
Production line is great for saving time, unless you make the same mistake
over and over on every piece....
I can reuse them as seat slats on later foldstools, but I'll have to
make a jig with a pin for the miter saw to hold them all in the same
position based off the incorrect hole......
Aude Aliquid Dignum
' Dare Something Worthy '
|Just drill a new hole. Think of the old one as a "feature".|
Your message has been successfully submitted and would be delivered to recipients shortly.