Hi, I was going to build a PWM to 0-10V converter, I came up with a good design that was nice and linear. Even bread boarded and spiced the critical parts butmy_triplenet
Whenever i decode to control my VFD from Mach3, the plan was to use a cheap isolated FET board to convert the PWM output to a 0 to 10 volt control voltage thatspencerserolls
In Mach3, is there a difference between Mill and Turn, either as to how spindle step&direction is implemented or used? Sincerely, Andrey Lipavskyalipavsky
The purpose of the group is for discussion of and bug reporting for Mach3 machine controller software.
Mach3 is supported by user manuals and customization documentation here ), by a range of "how to" videos - here , by a wiki aiming to explain Mach and CNC jargon - here and by a wiki on Mach3 Customization - here .
We try to use the "Minimal Moderation" method but we do not allow flames / verbal attacks on other list members, companies or other lists.
We ask that OT posts be identified in the Subject Line to make it easier for users to skip over that content that does not intrest them. We also ask you to use the cut and paste method of refining your replies so there are not 4 or 5 prior contributions in a message.
As usual, Spammers will be removed immediately. All requests for membership will be reviewed by a Moderator.
Questions on protocol on the list should be addressed to the List owner or one of the Moderators.
Thank you for your cooperation and good machining.
- Jul 24, 2003
- This is a restricted group.
- Attachments are not permitted.
- Members cannot hide email address.
- Listed in Yahoo Groups directory.
- Membership requires approval.
- Messages are not moderated.
- All members can post messages.