Loading ...
Sorry, an error occurred while loading the content.

136505Re: [mach1mach2cnc] Re: Running from "feed hold"

Expand Messages
  • Mark Mickelsen
    Aug 5, 2012
    • 0 Attachment
      Thanks much. I will try it.

      On Sun, Aug 5, 2012 at 1:40 PM, hydroxy@... <hydroxy@...>wrote:

      > **
      >
      >
      > Try the "Run From Here" command instead of cycle start. It will initiate a
      > "preparation move" to get back to the position immediately before the
      > highlighted line.
      >
      > Hope this does it for you.
      >
      > Chris
      >
      >
      > --- In mach1mach2cnc@yahoogroups.com, Mark Mickelsen <msmickelsen@...>
      > wrote:
      > >
      > > I was really hoping that someone could help me with this problem, but I
      > > guess that no one knows how to use Mach3 that well. Could someone give my
      > > Brian's email address so that I can ask him?
      > > Thanks,
      > > Mark
      > >
      > > On Thu, Jul 26, 2012 at 8:16 AM, msmickelsen <msmickelsen@...> wrote:
      > >
      > > > **
      >
      > > >
      > > >
      > > > I used to use a previous version of Mach3, 1.84, I believe. In it I
      > could
      > > > pause a run by clicking "feed hold". Then I could raise the bit to
      > clean
      > > > it, move it around so I could get to it, and when I was ready, I could
      > > > click "cycle start". Mach3 would then return the bit to the position
      > it was
      > > > in when I clicked "feed hold" and then continue the run. I recently
      > > > upgraded to R3.043.022. Now, if I try to do the same thing, it lets me
      > make
      > > > my adjustments but when I click "cycle start", it doesn't return the
      > bit to
      > > > where it was. It just starts executing with the bit where I moved it
      > to for
      > > > adjustment. Obviously, this ruins the run. It there a way to get Mach3
      > to
      > > > restore the position of the bit when I make an adjustment like it did
      > in a
      > > > previous version?
      > > > Thanks,
      > > > Mark
      > > >
      > > >
      > > >
      > >
      > >
      > > [Non-text portions of this message have been removed]
      > >
      >
      >
      >


      [Non-text portions of this message have been removed]
    • Show all 5 messages in this topic