Loading ...
Sorry, an error occurred while loading the content.

106912Re: [mach1mach2cnc] Spindle Setup with VFD

Expand Messages
  • gcode fi (hanermo)
    Apr 1 12:06 AM
      You need an analog out board, like the c6 from cnc4pc.
      It takes the step/dir and converts to 0-10v.
      I have some, they work fine.

      wildgrav wrote:
      > Hi All
      > Could someone please explain how you get 0-10 using step/dir in
      > Ports/Pins. Motor Outputs / Spindle. Where do the two pins go after
      > that. The VFD has 0-10 input and a common so how does step/Dir fit with
      > that.
      > Ports/Pins, Spindle Setup allows you to choose a pin for the relay and
      > the Step Direction for Motor control. Is there a flow chart for dummies?
      > Using SS and a C23.
      > Regards
      > Noel
    • Show all 11 messages in this topic