--- In email@example.com
, w1hkj <w1hkj@...> wrote:
> dek4rst wrote:
> > This is what I get when I run fldigi 3.10 from the command line.
> > doesn't seem to effect the program, but I would like to fix it if
> > possible. When I was using 3.03 version, it opened and ran clean
> > without any problems. The computer I'm running it on is an old
> > Latitude, with a dedicated, Full install of Puppy Linux 4.1.2. It
> > 466mhz celeron processor, 256 megs memory, and a 17 gig hdd. I'm
> > using fldigi 3.10 on the digital modes only, and not yet tried it
> > rig control....Any help would be appreciated...thanks
> > # fldigi
> > fldigi: Symbol 'hamlib_version' has different size in shared
> > consider re-linking
> > #
> You could compile the program from source without hamlib support.
> binary is build against hamlib.1.2.8. The earlier 3.03 was built
> against 1.2.7. When you installed the 3.10 pet perhaps the hamlib
> shared libs did not get installed correctly.
> At any rate it should not make any difference. The message is just
> friendly warning from your dynamic loader.
OK Thanks, I believe that I've got hamlib 1.2.7 so that might be the