Re: redhat 8.0 hangs at IDE initialization
- RH 9.0 installed and booted OK
RH 9.0 (which worked) came with 2.4.20-8 and the RH 8.0 distribution
came with kernel 2.4.18-14 (and would not boot). Maybe 2.4.18-14
does not support the IDE controller in the D600.
Thanks for the suggestion.
--- In firstname.lastname@example.org, Christian Soeller
> tcart128 wrote:boot.
> > I just installed RH 8.0 on a Dell D600. The system hangs during
> Others have reported success with RH 9 on D600 and 600m (see list
> archives). Maybe you should give that a try.
- No help from me, I am afraid. But FWIW, I have the same problem with a
Latitude LS and RH 8.0. Hangs at the same point. Boots fine with the
boot floppy. I am stuck too. Is there any chance that RH 9.0 would
--- In email@example.com, "tcart128" <mass170@n...>
> I just installed RH 8.0 on a Dell D600. The system hangs duringboot.
> Here are the last few lines during the boot sequence:
> Uniform Multi-Platform E-IDE driver Revision: 6.31
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086,
> PCI: Enabling device 00:1f.1 (0005 -> 0007)
> PCI: Found IRQ 11 for device 00:1f.1
> PCI: Sharing IRQ 11 with 00:1d.2
> PCI: Sharing IRQ 11 with 02:00.0
> PCI_IDE: chipset revision 1
> PCI_IDE: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xbfa0-0xbfa7, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0xbfa8-0xbfaf, BIOS settings: hdc:DMA, hdd:pio
> It hangs at this point. My first attempt at this installation was
> with a dual boot system. My latest attempt is a single boot system
> with only RH 8.0 installed. The kernel with this installation is
> 2.4.18-14. Any help will be appreciated.