Re: [ksurfschool] Flat kite accident?
All flat kites 12m or under can be raise to a vertical C easily by
pulling on one of the back line in ridable wind.
For larger flat kites (e.g. Waroo 14m and larger), you can launch them
the same way as a classic but don't have to swim much toward the kite.
The other option is to push the bar out, pull around 1m or 2m of one of
the back lines and swim/walk toward the other direction to help the kite
to raise to a vertical C. We taught that method to the student and we
can raise the 16m Waroo fairly confidently (haven't try to raise the 20m
Waroo yet) in wind just enough to ride and learn. For other flat kites,
you can probably do similarly.
>In a message dated 7/12/2006 5:17:57 A.M. US Mountain Standard Time,
>I have been using the Waroo extensively for the whole winter, spring and
>almost half of the summer now!
>P.S., The stopper ball on the chicken loop is great and make the kite
>behave similar to a classic when you are not holding the bar (for
>deadman trick or other reasons), but at the same time, it makes the kite
>only as safe as the classic unless the tension on the stopper ball is
>set to real low (then you cannot do the deadman trick anyway).
>Personally, I would set the stopper ball as far as possible on land and
>may move it in closer when in deep water. The other option is to always
>set it to as far as your arm can reach or not having the stopper ball at
>all especially if you want a safer flat kite.
>Hi, Check out the "punch through" stopper on the sonic, I made one of these
>for my Waroo 14, it has enough tension for tricks and unspinning the bar but
>can be pushed through with your bar to get full depower back.
>Also, I am having a difficult time water relaunching the 14 waroo in light
>winds, any advice or Vids out there, I have tried everything on Bests site and
>do eventually get it but often after a long time in the water and have not
>had to try it without my board yet.
> I have been self landing as you described in an earlier post and it works
>perfect, thanks for that one ;)
>[Non-text portions of this message have been removed]