Loading ...
Sorry, an error occurred while loading the content.

397Re: [j4x-owners-group] head plug

Expand Messages
  • William Stellin
    Jun 13 10:47 AM
      If you can, remove the Tee and clean or replace. The hose can be cleared but not the Tee
      If you can't get the hoses off, cut the Tee in half or thirds without cutting the hose. All the buildup of rock is probably in the plastic tee. You can pry it loose from the hose only after cutting the tee into pieces. Don't try acid as it is way too dangerous. Just replace the tee and any elbows that are below the water line. The seacock should be fine and easy to clean once you remove the hose. Squeezing and flexing the hose will dislodge the calcium but the hose must have an open or free end so the stuff can fall out. It will never go throuh tees or elbows even if they are clean. 
      Bill Stellin.  Jaywalker

      Sent from my iPod

      On Jun 13, 2011, at 12:33 PM, Robert Thuss <Robert.Thuss@...> wrote:


      That is absolutely the worst fix-it job on the boat. Drain-o won’t help and if you can’t dig out the clogged paper from underneath, then you will have to disconnect or cut the hose pipe. Beware that it may be under pressure from the head. Safety glasses, a paint suit, rubber gloves and lots of paper towels will be necessary! Robert (Jade USA 50777)



      From: j4x-owners-group@yahoogroups.com [mailto:j4x-owners-group@yahoogroups.com] On Behalf Of cdsail@...
      Sent: Monday, June 13, 2011 10:29 AM
      To: j4x-owners-group@yahoogroups.com
      Subject: [j4x-owners-group] head plug



      the aft head is seemingly plugged at the tee. I have worked from all sides but it looks like it is at the tee that goes either to the holding tank or to the thru hull when pumbing overboard. I have tried to push a snake from the vented loop through the tee but it just will not turn the corner.

      I hate to cut the hose above the tee but it looks like the only choice. Has anyone used drain-no and got results or some other option?

      Headed toward destruction soon...

      The information contained in this communication is confidential, may be privileged and is intended for the exclusive use of the above named addressee(s). If you are not the intended recipient(s), you are expressly prohibited from copying, distributing, disseminating, or in any other way using any information contained within this communication. If you have received this communication in error please contact the sender by telephone or by response via mail.

      We have taken precautions to minimize the risk of transmitting software viruses, but we advise you to carry out your own virus checks on any attachment to this message. We cannot accept liability for any loss or damage caused by software viruses.

    • Show all 16 messages in this topic