RE: [irlp-embedded] db9 pin assignments
- Since I am using the standard embedded scripts and the docs call for those two to be jumpered, then I assume that I am.
From: firstname.lastname@example.org [mailto:email@example.com] On Behalf Of David Cameron - IRLP
Sent: Sunday, May 06, 2007 7:36 PM
Subject: RE: [irlp-embedded] db9 pin assignments
If you are using things that use AUX1 for keying, then yes.
On Sun, 6 May
2007, Emit Hurdelbrink wrote:
>Perfect, thanks Dave! I assume the embedded node also needs the jumper
>between pins 2 & 3 as in the docs right??
irlp-embedded@ yahoogroups. com]
>On Behalf Of David Cameron - IRLP
> Sent: Sunday, May 06, 2007 7:27PM
>Subject: Re: [irlp-embedded] db9 pin assignments
>The DB-9 Output is described in the embedded Manual, located in the
>files area of this yahoogroup. It describes on Page 2 that the wiring is
>the same as the standard version 3.0 board, and that audio output is
>available on pin 9.
>3 IRLP board from the install
> This means you take the wiring for a version
http://www.irlp. net/new-install/ Ver3_Wiring. pdf>
>net/new-install/ Ver3_Wiring. pdf
>radio's transmit audio to pin 9.
> and then add the
>Mon, 7 May 2007, Emit Hurdelbrink wrote:
> Dave Cameron
>to find the pin assignments for the DB9 connector
>> I have been trying
>> from the embeddednode to a Motorola M120 Radio. I found the page
>> that described theradio 16 port pin but where do they go.
>> Thanks in