Loading ...
Sorry, an error occurred while loading the content.


Expand Messages
  • Alan M
    Dave, I discoverd port 80 and others blocked by my ISP which may have created the problem that led to me re-installing install-ra trying to sort the problem
    Message 1 of 3 , Mar 13, 2013
    • 0 Attachment

      I discoverd port 80 and others blocked by my ISP which may have created the problem that led to me re-installing "install-ra" trying to sort the problem out and created a new one.

      I got the blocked ports issue sorted out just before you looked at the matter.

      Many thanks for your assistance. The remote access now works fine.

      Alan Mitchell

      --- In irlp-embedded@yahoogroups.com, "David Cameron (IRLP)" <dcameron@...> wrote:
      > Well remote-admin was already installed on your system, and then what
      > you did was re-install it on top, using different ports - even with the
      > 2GB flash drive installed.
      > So now you have a port conflict between http and ssh.
      > I was able to log into your node remotely, and fix the issue.
      > Your embedded node's SSH listens on port 15426, so you have to use that
      > port with Putty (SSH), and WinSCP.
      > Now the web port is listening on port 80, like it should, and I am
      > prompted for a username and password.
      > Dave Cameron
      > VE7LTD
      > On 3/12/2013 7:09 PM, Alan M wrote:
      > > I am unable to access my embedded node from a remote location using
      > > http://stn6584.ip.irlp.net/control/
      > > Port forwarding of 15426 and 80 to (node LAN address) is in place. When trying to access remotely a message comes back that the server has dropped the connection. It says wait a few minutes and try again but to no avail.
      > >
      > > I have installed install-ra per http://www.irlp.net/owners/remote-admin.html but get error messages during installation to effect "- (Re)starting HTTP service ....
      > > Starting httpd: (98)Address already in use: make_sock: could not bind to address [::]:15426
      > > no listening sockets available, shutting down
      > > Unable to open logs"
      > >
      > > Putty and WinSCP work fine within the LAN but remote access from another location will not function. That is, no connection is possible from outside my router. I have also followed instructions from portforward.com re my router TP Link TD-W8960N .
      > >
      > > The embedded node is fitted with the 2gb flash drive. The node works fine but remote access is not functioning.
      > >
      > > Can some tests be run and I will appreciated assistance and suggestions.
      > >
      > >
    Your message has been successfully submitted and would be delivered to recipients shortly.