Loading ...
Sorry, an error occurred while loading the content.

Re: [irlp-embedded] Re: kenwood tmv-71 jumper setting

Expand Messages
  • Christopher Schulte
    I have the mcp2a software, and will take a look and see if I can change that, I don t have much luck with setting jumpers... Chris, w8cjs ... From: ve7ltd To:
    Message 1 of 4 , Apr 9, 2012
    • 0 Attachment
      I have the mcp2a software, and will take a look and see if I can change that, I don't have much luck with setting jumpers...
      Chris, w8cjs
      ----- Original Message -----
      From: ve7ltd
      Sent: Monday, April 09, 2012 5:08 PM
      Subject: [irlp-embedded] Re: kenwood tmv-71 jumper setting

       

      It looks like it defaults to HIGH. But it also looks like it can be changed in the MCP-2A software.

      I don't have one here to test, but maybe someone else has the answer. It should be the same on the D700A, as they are very similar radios.

      Dave Cameron
      VE7LTD

      --- In irlp-embedded@yahoogroups.com, "Christopher Schulte" <w8cjs@...> wrote:
      >
      > I am going to be using the 440 side of a kenwood tmv-71a and an embedded node for a simplex set up on 445.450. I am wondering what the cos jumper needs to be set at for this to work? According to the documentation, most radios use cos set to active low, which if I remember my reading correctly, is the default setting on these nodes. Will I need to change that for the V71?
      >
      > Thanks, and 73,
      > Chris, w8cjs
      >

    Your message has been successfully submitted and would be delivered to recipients shortly.