Loading ...
Sorry, an error occurred while loading the content.

Re: Changing IP on embedded computer

Expand Messages
  • ipscone
    Didn t know I could change the base address of the router. That does make more sense. Thanks,
    Message 1 of 3 , May 28, 2009
    • 0 Attachment
      Didn't know I could change the base address of the router. That does make more sense.

      Thanks,

      --- In irlp-embedded@yahoogroups.com, "David Cameron (IRLP)" <dcameron@...> wrote:
      >
      > The command netconfig can be used to change the IP address of your node.
      > Do not forget to run "flash_sync" to save the IP change.
      >
      > I would suggest changing the base addressing of your router to be
      > compatible so you can just take the node from inside or out without
      > changing anything.
      >
      > Dave Cameron
      >
      > ipscone wrote:
      > >
      > >
      > >
      > > How difficult is it to change the IP of my node? What are the steps? Do
      > > I have to notify whomever generated my node information?
      > >
      > > There may come a time when I change my broadband access and/or my
      > > network router. Some routers use 198.162.0.x and some use 198.162.1.x
      > > and some may use entirely different base numbers. So, should I decide to
      > > change my router,
      > >
      > > 1) can I make all the changes on my end?
      > > 2) Where are the changes made?
      > > 3) Do I have to notify anyone? Will my node number remain the same?
      > > 4) If it might change, is there a way to keep it the same?
      > >
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.