978Re: [irlp-embedded] Re: Node rebooted will it recover? No static IP.
- Feb 1, 2009Thanks to all that helped. I went to the site this morning and reset the computer.73's Gary K2ACY
On Feb 1, 2009, at 1:55 AM, "David Cameron (IRLP)" <dcameron@...> wrote:
The DHCP service will run continually, so it should grab an IP. I am not
sure of the interval. It would depend if the ethernet card had a "link
up" or not during the boot cycle. If not, it may not come back up.
However, is there any way to assign a static IP to the system? Then this
will never happen again.
Gary Paul wrote:
> Does the embedded node reboot in a script file that runs at a specific time?
> I was thinking that the node would just sit there until it was rebooted
> manually to grab an IP.
> Thanks & 73's
> Gary K2ACY
> On Feb 1, 2009, at 12:26 AM, "Don" <donmor46@gmail. com
> <mailto:donmor46@gmail. com>> wrote:
>> It should reboot and choose an ip from the router but you will most
>> likely have to reset the portforwarding in your router unless you are
>> lucky and have it choose the one it was on before.
>> Don VE7EDA
>> --- In irlp-embedded@ yahoogroups. com
>> <mailto:irlp- embedded% 40yahoogroups. com>, "garyp609" <gary.paul@. ..>
>> > Hello,
>> > I rebooted my Embedded Node tonight remotely through Putty with the
>> > reboot command. When the node booted back up the router and internet
>> > connection were down. The node booted back up without getting assigned
>> > an IP address. I am not using a static IP. The internet connection is
>> > now back up. Will my node recover and grab an IP address from the
>> > router or do I have to go to the repeater site and reboot the node
>> > manually now that the router and internet connection are back up?
>> > Thanks & 73's
>> > Gary K2ACY
- << Previous post in topic Next post in topic >>