950Re: [irlp-embedded] Embedded Node to RC210 Controller ECHO Effect
- Jan 11, 2009Where is that setting? I have port 3 the IRLP node as half duplex. Non repeating port.Thanks for you help.Gary K2ACY
On Jan 11, 2009, at 2:16 AM, "Ted Maczulat" <tmaczulat@...> wrote:In the RC210 is the port you have the node connected to configures as a repeater or as a remote base? It should be set as a remote not as a repeater.Ted----- Original Message -----From: Gary PaulSent: Saturday, January 10, 2009 7:14 PMSubject: RE: [irlp-embedded] Embedded Node to RC210 Controller ECHO Effect
Any idea why when a node times out when connected the disconnected message has a reverb on it? It seems to be playing twice just milliseconds apart.
Have you contacted Ken Arck and asked him his opinion? It sounds to me
like you have the port for IRLP not set right.
> I have an embedded node hooked directly to port 3 of my Arcom
> controller. Port 1 & 2 are Kenwood TKR repeaters. When I link the
> embedded node to port 1 or 2 I get a slight echo effect. By turning off
> port 3 in the Arcom controller and just leaving port 1 & 2 on and
> linked together the audio is fine. Is there a setting in the embedded
> node that I need to set because it's hook directly to a repeater
> controller? I have checked aumix and the only 'R' is on LINE and it is
> at zero. I have Volume, PCM and IGAIN controls enabled. All other
> sliders are zeroed. Also if this helps. I get an echo effect on the wav
> file played when a user times out on EchoLink. Any help would be
> Thanks & 73's
No virus found in this incoming message.
Checked by AVG - http://www.avg. com
Version: 8.0.176 / Virus Database: 270.10.5/1885 - Release Date: 1/9/2009 7:59 PM
- << Previous post in topic Next post in topic >>