Loading ...
Sorry, an error occurred while loading the content.

Messages List

4925

found a loader...I think

I have been looking for a loader for my b275 for months. I would prefer a 1501 or 1550, but no luck. So I found a 2000 complete with controls and front
mooredesign02
Aug 12
#4925
 
4924

New Guy

Just a post to say hello, I just joined this group and am looking forward to reading and learning about the tractor I just bought. It is a B414 with loader. I
plastick44
Jul 15
#4924
 
4923

B414 brake linkage

I am attempting to revive a B414 I bought and found that all the brake linkage from the pedals to the actuators is gone on both sides. Does anyone know of a
kd1my_2000
Jun 11
#4923
 
4922

Re: B414 1964 3-point leaking down

Posted the picture of the piston/seal in the "Photos" section.
scottpdirksen
Jun 7
#4922
 
4921

Re: B414 1964 3-point leaking down

The last reply, I tried to post a picture of the piston but that did not work. It was not the O-ring type, It had the fiber-composite type seal which is held
Scott Dirksen
Jun 7
#4921
 
4920

Re: B414 1964 3-point leaking down

From: "scottpdirksen@... [internationalbseriestractors]" To: internationalbseriestractors@yahoogroups.com
Scott Dirksen
Jun 5
#4920
 
4919

B414 1964 3-point leaking down

Hello, I am new to the group. Living in South Louisiana. Earlier this year, I purchased a home with 10 acres and also acquired the tractors of the previous
scottpdirksen
Jun 4
#4919
 
4918

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

IH B275 with Bosch 80003 Glow Plugs,OEM Manual Switch type relay. Plugs are wired in series. To: internationalbseriestractors@yahoogroups.com From:
Ed Moore
May 11
#4918
 
4917

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

which model tractor do you have? What Make # glow plug? Ford What # Ford relay? Thanks   From: "Bart Hull BartDHull@...
GARY SCHAEFER
May 11
#4917
 
4916

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

If you put in the Mercedes glow plugs you won't have to worry about battery problems anymore. 20 seconds of heat in 30 degree F weather and it starts right up.
Bart Hull
May 11
#4916
 
4915

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

Thanks for all the help. My battery is starting to crap out. It can't be good for a the battery causing the dead short to heat the plugs. Probably nothing I
Ed Moore
May 10
#4915
 
4914

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

Hi Ed. Good to know you have a working engine. It´s hard too see the glow in bright daylight until it becomes rather too much in my opinion. For heating time
thorhallurr
May 10
#4914
 
4913

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

Ok... I got it! The Bosch plugs 80003 are coil type and run on the .9 volt like the original. I blew one when I hit it with 12volts(I was frustrated and paid
Ed Moore
May 9
#4913
 
4912

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

Pencil type, those are the most popular Please delete all email addresses from incoming messages before forwarding From:
Phil Tibbetts
May 9
#4912
 
4911

Re: I'm ordering Bosch 80003/ 0250001016 to put in my 275

Hi Ed. Bosch say on their website: "There are two types of glow plugs based on their construction - Coil type and Pencil type glow plugs. Coil type glow plugs
thorhallurr
May 9
#4911
 
View First Topic Go to View Last Topic
Loading 1 - 15 of total 4,925 messages