Re: Blown fuse on Intellibrain
- Hi Peter,
The inductor L1 is this part:
The cap in C15 should be oriented with the solid line oriented toward the left side of the board, near the green power header block.
--- In email@example.com, "Peter Chatterton" wrote:
> I've just discovered another ruined component.
> It's a vertically mounted coil in a plastic case
> that's marked 100 on top. It's right next to the
> BTW, what is the polarity of the old cap? I've
> broken off the old plastic just leaving two tabs,
> one of which is much bigger than the other. This
> tab was visible after the explosion, raised above
> the upper surface and covered in soot.
> Hope you can help,
> ----- Original Message -----
> From: ridgesoft
> To: firstname.lastname@example.org
> Sent: Monday, December 10, 2012 12:41 PM
> Subject: [intellibrain] Re: Blown fuse on Intellibrain
> Hi Peter,
> If you are referring to the component in C15 on the IntelliBrain2 board, it is a capacitor. It is this part:
> RidgeSoft Support
> --- In email@example.com, "Peter Chatterton" wrote:
> > I've just blown the main fuse with too many AC volts.
> > It's just behind the power supply and is light brown
> > with a 3 mm or so flap on it (now).
> > How do i fix it?
> > Peter
> > P.S. Isn't it supposed to be auto-reset? Or is that
> > just for the servo one? If so, why?