Loading ...
Sorry, an error occurred while loading the content.

Re: Blown fuse on Intellibrain

Expand Messages
  • ridgesoft
    Hi Peter, The inductor L1 is this part: http://www.digikey.com/product-detail/en/PM43-100M-RC/M8503CT-ND/775571 The cap in C15 should be oriented with the
    Message 1 of 5 , Jan 13, 2013
    • 0 Attachment
      Hi Peter,

      The inductor L1 is this part:

      http://www.digikey.com/product-detail/en/PM43-100M-RC/M8503CT-ND/775571

      The cap in C15 should be oriented with the solid line oriented toward the left side of the board, near the green power header block.

      Regards,

      RidgeSoft Support

      --- In intellibrain@yahoogroups.com, "Peter Chatterton" wrote:
      >
      > I've just discovered another ruined component.
      > It's a vertically mounted coil in a plastic case
      > that's marked 100 on top. It's right next to the
      > cap.
      >
      > BTW, what is the polarity of the old cap? I've
      > broken off the old plastic just leaving two tabs,
      > one of which is much bigger than the other. This
      > tab was visible after the explosion, raised above
      > the upper surface and covered in soot.
      >
      > Hope you can help,
      > Peter
      >
      > ----- Original Message -----
      > From: ridgesoft
      > To: intellibrain@yahoogroups.com
      > Sent: Monday, December 10, 2012 12:41 PM
      > Subject: [intellibrain] Re: Blown fuse on Intellibrain
      >
      >
      >
      > Hi Peter,
      >
      > If you are referring to the component in C15 on the IntelliBrain2 board, it is a capacitor. It is this part:
      >
      > http://www.digikey.com/product-detail/en/T491D107K010AT/399-3769-2-ND/818629
      >
      > Regards,
      >
      > RidgeSoft Support
      >
      > --- In intellibrain@yahoogroups.com, "Peter Chatterton" wrote:
      > >
      > > I've just blown the main fuse with too many AC volts.
      > > It's just behind the power supply and is light brown
      > > with a 3 mm or so flap on it (now).
      > > How do i fix it?
      > >
      > > Peter
      > >
      > > P.S. Isn't it supposed to be auto-reset? Or is that
      > > just for the servo one? If so, why?
      > >
      >
    Your message has been successfully submitted and would be delivered to recipients shortly.